Tile Design

September 26, 2017
Eskay Metal Fabricating Home Page

XT-2000 Adhesive Data Sheet for Metal Tiles

MASTIC ADHESIVE FOR REAL METAL TILES


PRODUCT DESCRIPTION: XT-2000 is a super-strong synthetic-latex based, mastic adhesive specifically formulated to provide a permanently flexible bond and high initial tack for adhering tiles.

USES: Used to install Real Metal Tiles over a multitude of substrates that includes sealed drywall, plywood, particle board, concrete block and nonporous surfaces when special installation methods are used.

ADVANTAGES: Environmentally safe (0.00% Volatile Organic Compounds --"zero VOC"); tested in accordance with EPA Method #24, the only official test recognized by the EPA and all government agencies. Easy to apply: one coat trawled onto wall surface is all that is needed. Allows tiles to be repositioned or realigned. Xt-2000 is non-flammable, has no offensive odor, and is water-based for easy water clean-up.

LIMITATIONS: Water-based adhesives cure slower than solvent materials and should not be used when humidity exceeds 80%. Not freeze-thaw stable in storage or transit, so keep from freezing.

COMPOSITIONS AND MATERIALS: Synthetic latex dispersion. Contains surfactants, inert fillers, flame retarders and other compatible additives.

PACKAGING: Packaged in quart, one-gallon and five-gallon pails.

COLORS: White dries clear. ODOR: Minimal acrylic paint odor.

STORAGE LIFE: One year when stored in original, tightly sealed container. Keep from freezing.

PRECAUTIONS: Synthetic latex can be irritating. Avoid contact with skin - in case of contact, wash thoroughly with water. For eyes, get prompt medical attention. Provide adequate ventilation. Keep out of reach of children.

CLEANING: Wash Real Metal Tiles and tools immediately with water. Cured adhesive may be removed with ordinary paint remover (mineral spirits).

MAINTENANCE: Adhesive is permanent and maintenance-free. Adhesive must not be exposed to excessive moisture or cleaners when maintaining the tiles. (See caulk-grouting method section above for prevention methods) Damaged tiles may be replaced by mechanically removing cured adhesive. Re-apply adhesive and new tiles in normal manner.

TECHNICAL DATA:
Base: Synthetic Latex
Solvents: Water
Solids:60-64%
Application Temperature Limits: 60F to 80F
Flammability: Non-Flammable
Consistency: Medium Viscosity Paste
Application: 1/8" V-Notched Trowel
Coverage: Approximately 120 Sq. Ft. / gallon using recommended trowel
UL Listed: Meets/exceeds Class I/A fire code requirements
Volatile Organic Compounds (VOC): Zero (0.00%) as tested to EPA Method #24